Q1: Gate will not open or close with Manual Switch or Transmitters.

Q2: Gate will not completely open or close.

Q3: Gate opening and closing with No imput signal.

Q4: Gate will not open manually.

Q5: Gate only opens and will not close.

Q6: Gate only closes and will not open.

A1:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Dead Battery, terminals disconnected or corroded.
3. Interlock Mechanism binding.
4. Interlock Solenoid not operating.
5. Loose or broken V-Belt.
6. Control Board damaged or plugs and terminals loose.

A2:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Current Sensitivity not adjusted correctly (Gently turn full clockwise).
3. Run Timer set too low (Reference Gate Board Instructions).
4. Low Battery - Recharge.
5. Tension on V-Belt not adequate.
6. Proximity Switch engaging too soon.
7. Gate out of Balance - Adjust Spring Tension on Operator Arm (Remove top side panel).

A3:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Short circuit in electrical system.
   1. Moisture in Push Button.
   2. Moisture in Control Board Rcvr. - Dry out box and remove/replace Control Board.
   3. Transmitter button stuck.
   4. Outside Radio interference - Change
   5. Down Proximity Magnet not aligned properly.
3. Low Battery - Recharge.

A4:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Check Interlock Mechanism on inside of the Operator. If it is not moving freely by hand or with the override lever, try the following:
   1. Remove the outside top skin adjacent to door and Oil the Pivot Bolt.
   2. Check Solenoid operation.
3. Check for broken Springs.
4. Check V-Belt tension.

A5:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Does gate run only in open direction even if stopped mid-cycle?
   If yes, then Proximity Switch "B" is stuck closed and must be replaced.
   Remove panel adjacent to door and Solder all wire splices.

A6:

1. Disconnect all Accessories from Gate, then try the Transmitter to open/close.
2. Does gate run only in closed direction even if stopped mid-cycle?
   If yes, then Proximity Switch "A" is stuck closed and must be replaced.
   Remove panel adjacent to door and Solder all wire splices.